Removal Method Of Adhesive Thermal Label Sticker After Use
Adhesive thermal label sticker also called self-adhesive label material, which is a composite material made of paper, thin film, or special material, coated with adhesive on the back, and coated with silicon protective paper. After the use of the sticker, some hard objects often leave sticky marks on the surface, It affects the beauty and hard to clear, Let's give you a brief introduction.
Ⅰ, Remove the sticker surface with a blade or an ink shovel and then use gasoline or acetone to remove the residual glue, with cloth coated with gasoline or acetone, just wipe the residual glue. Gasoline, acetone is very good organic solvents, can dissolve adhesive label glue.
Ⅱ, Heating softens the viscose of the double-sided adhesive: Soften the sticky glue by blowing it with a blower, when the adhesion of the double-sided adhesive becomes weaker, it can be removed more easily. If there are any small marks, wipe them with a clean water that removes nail polish.
Ⅲ, The intermixture of soap with a little ammonia and turpentine can remove a lot of dirt and make the glass surface more glossy(this item applies to tiles, ceramics, glass, etc.)
Ⅳ, If the size of the adhesive label is not too large, it can be swabbed with the cotton wipe with nail wash.
V, Wipe with a rag dipping with wind medicated oil, after a while, uncover the label and leave no trace.
Ⅵ, Wipe with special detergent or sneaker decontamination cream.
Ⅶ, Take a piece of dry cloth covered with vinegar to cover the whole double-sided mark after the double-sided adhesive is completely soaked, it can be easily removed with a ruler.
Finally, when purging, whether with soap or vinegar, it must let these supplies completely soak wet double-sided glue mark, so it can easily and effectively remove the self-adhesive mark.